Ford E Series Vans

Ford E Series Vans

Ford "E" Series Vans

Installation instructions for Block kit ATMFSFD


Ford "E" Series Vans with #6 and #12 Springlock fittings above drivers side wheel well under the brake booster.


CAUTION: Refrigerant under high pressure, evacuate the system before servicing.


1.  Unhook aluminum lines going to the rear unit located under the brake booster on the drivers side, using springloc removal tool.


2.  Remove the original o-rings from the original fittings.


3.  Replace with new lubricated o-rings and install supplied fittings


4.  When re-servicing freon adjust freon amount to approximately 1 pound LESS than factory set amounts and adjust accordingly.




There are no products to list in this category.